Home › Drivetrain › U241E (AUTOMATIC TRANSMISSION / TRANSAXLE) › DIFFERENTIAL OIL SEAL › 2013.04–2016.05
RM24M0E _52 Drivetrain _059578 U241E AUTOMATIC TRANSMISSION / TRANSAXLE _0292104 DIFFERENTIAL OIL SEAL A

U241E AUTOMATIC TRANSMISSION / TRANSAXLE  DIFFERENTIAL OIL SEAL  REPLACEMENT  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 2.DRAIN AUTOMATIC TRANSAXLE FLUID

a.

Remove the drain plug, gasket and drain ATF.


b.

Install a new gasket and drain plug.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)


Hide 43420 3.REMOVE FRONT DRIVE SHAFT ASSEMBLY

a.

Hide 43457 4.REMOVE DRIVE SHAFT BEARING BRACKET

a.

Remove the 3 bolts and bracket.


Hide 35111D 5.REMOVE TRANSAXLE HOUSING OIL SEAL LH AND RH

D025835E08
1.063,0.219 1.396,0.396 0.333,0.177 10 false SST

a.

Using SST, tap out the oil seal LH.

SST
09308-00010  


b.
D025827E05
1.792,0.208 2.083,0.375 0.292,0.167 10 false SST

Using SST, tap out the oil seal RH.

SST
09308-00010  


Hide 35111D 6.INSTALL TRANSAXLE HOUSING OIL SEAL LH AND RH

a.

Coat the lip of a new oil seal LH with MP grease.


b.
D025836E06
1.188,1.635 1.49,1.813 0.302,0.177 10 false SST

Using SST and a hammer, tap in the oil seal LH.

SST
09608-32010  
09950-70010  (09951-07150)

Standard depth:

0 +-0.5 mm (0 +-0.020 in.)



c.

Coat the lip of a new oil seal RH with MP grease.


d.
C129401E05
1.813,0.49 2.333,0.271 2.333,0.271 2.094,0.677 false 2.375,0.156 2.677,0.313 0.302,0.156 10 false SST

Using SST and a hammer, tap in the oil seal RH.

SST
09608-32010  
09950-70010  (09951-07150)

Standard depth:

0 +-0.5 mm (0 +-0.020 in.)



Hide 43457 7.INSTALL DRIVE SHAFT BEARING BRACKET

a.

Install the bracket with the 3 bolts.

Torque:
64 N*m (653 kgf*cm, 47 ft.*lbf)


Hide 43420 8.INSTALL FRONT DRIVE SHAFT ASSEMBLY

a.

Install the front drive shaft (see page Drivetrain>DRIVE SHAFT>FRONT DRIVE SHAFT ASSEMBLY>INSTALLATION).


Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 10.ADD AUTOMATIC TRANSAXLE FLUID

Fluid type:

Toyota Genuine ATF WS


Hide 11.INSPECT TRANSAXLE FLUID LEVEL