Home › Drivetrain › AXLE › REAR AXLE HUB BOLT
RM24M0E _52 Drivetrain _059581 AXLE _0292139 REAR AXLE HUB BOLT A

AXLE  REAR AXLE HUB BOLT  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 47750A 2.REMOVE REAR DISC BRAKE CALIPER ASSEMBLY LH

a.
A137317

Remove the 2 bolts and caliper.


Hide 42431 3.REMOVE REAR DISC

Hide 42312E 4.REMOVE REAR AXLE HUB BOLT

a.
C136794E01
2.262,0.713 2.472,0.503 false 2.472,0.503 2.606,0.503 false 2.628,0.416 2.920,0.572 0.291,0.156 10 SST

Using SST and a brass bar or equivalent to hold the axle shaft, remove the hub bolt that needs to be replaced.

SST
09650-17011  


Hide 42312E 5.INSTALL REAR AXLE HUB BOLT

a.

Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.


b.
C136795

Using a brass bar or equivalent to hold the rear axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer.


Hide 42431 6.INSTALL REAR DISC

Hide 47750A 7.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH

a.
A137317

Install the caliper with 2 bolts.

Torque:
88 N*m (900 kgf*cm, 65 ft.*lbf)


Hide 8.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)