Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1.REMOVE REAR WHEEL
89516
2.REMOVE SKID CONTROL SENSOR WIRE
46430
3.REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY
46420
4.REMOVE NO. 2 PARKING BRAKE CABLE ASSEMBLY
48540
5.REMOVE REAR SHOCK ABSORBER ASSEMBLY LH
Support the rear axle beam with a jack.
Place a wooden or rubber block between the jack and arm.
Remove the nut and bolt from the shock absorber lower side.
While fixing the nuts in place, loosen and remove the bolts.
Slowly lower the jack, and disconnect the shock absorber from the axle beam.
48259A
6.REMOVE REAR COIL SPRING INSULATOR UPPER LH
Remove the insulator upper from the coil spring.
48231B
7.REMOVE REAR COIL SPRING LH
Remove the coil spring from the rear axle beam.
48258C
8.REMOVE REAR COIL SPRING INSULATOR LOWER LH
Remove the insulator lower from the rear axle beam.