Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292163 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The procedure listed below is for the LH side.

·

The skid control sensor is a component of the rear axle hub and bearing assembly. If the skid control sensor needs to be replaced, replace the rear axle hub and bearing assembly.

·

If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 2.REMOVE REAR WHEEL

Hide 67918D 3.REMOVE REAR DOOR SCUFF PLATE LH

Hide 67918E 4.REMOVE REAR DOOR SCUFF PLATE LH

Hide 67872A 5.REMOVE NO. 1 SLIDE DOOR WEATHERSTRIP LH

Hide 64735G 7.REMOVE DECK TRIM SIDE SERVICE HOLE COVER LH

Hide 64766 8.REMOVE QUARTER TRIM JACK COVER SUB-ASSEMBLY (for LH Side)

Hide 64740A 9.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for Captain Seat Type)

Hide 64740A 10.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for Except Captain Seat Type)

Hide 89516 11.REMOVE SKID CONTROL SENSOR WIRE

a.
C130710

Disconnect the skid control sensor wire connector.


b.
C130711

Disconnect the grommet of the skid control sensor wire from the hole of the side member.


c.
C130712E04
1.781,0.75 1.948,0.938 0.167,0.188 10 false A 0.281,1.49 0.448,1.677 0.167,0.188 10 false C 0.958,3.01 1.125,3.198 0.167,0.188 10 false D 2.24,2.594 2.406,2.781 0.167,0.188 10 true B

Remove the bolt (A) and sensor clamp (B) from the side member.


d.

Remove the bolt (C) and sensor clamp (D).


e.
C130713

Remove the 2 grommets.


f.
C130714

Disconnect the skid control sensor wire connector from the speed sensor.


Hide 12.REMOVE REAR DISC BRAKE CALIPER ASSEMBLY LH

Hide 42431 13.REMOVE REAR DISC

Hide 42440 14.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH

a.

Remove the rear axle hub and bearing assembly LH (See page Drivetrain>AXLE>REAR AXLE HUB>REMOVAL).

HINT:
·

The skid control sensor is a component of the rear axle hub and bearing assembly. If the skid control sensor needs to be replaced, replace the rear axle hub and bearing assembly.

·

If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.