67914B
1.REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)
67913B
2.REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)
62112
3.REMOVE COWL SIDE TRIM BOARD LH (for LHD)
62111C
4.REMOVE COWL SIDE TRIM BOARD RH (for RHD)
55606
5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55432B
6.REMOVE INSTRUMENT PANEL FINISH PANEL LOWER (w/o Knee Airbag)
55432B
7.REMOVE INSTRUMENT PANEL FINISH PANEL LOWER (w/ Knee Airbag)
8.LOOSEN LOCK NUT
9.REMOVE REAR WHEEL
10.REMOVE REAR DISC BRAKE CALIPER ASSEMBLY
42431
11.REMOVE REAR DISC
46430
12.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Disconnect the cable from the parking brake shoe lever (see page Brake>PARKING BRAKE>PARKING BRAKE ASSEMBLY>DISASSEMBLY).
Remove the 2 bolts and disconnect the cable from the backing plate.
46420
13.DISCONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY
Use the same procedures described for the No. 3 cable.
46341
14.REMOVE PARKING BRAKE EQUALIZER
Disconnect the 3 cable ends and then remove the equalizer.
46356
15.REMOVE EQUALIZER SUPPORT BRACKET
Remove the 4 bolts and bracket.
46430
16.REMOVE PARKING BRAKE CABLE ASSEMBLY
Remove the No. 2 parking brake cable as follows.
Remove the 2 clamp bolts (labeled A) and parking brake cable No. 1 support bracket (labeled B) from the crossmember.
Remove the parking brake cable guide RH (labeled C) from the crossmember.
Remove the clamp bolt (labeled D) from the beam bracket.
Remove the clamp bolt (labeled E) from the beam bracket.
Remove the No. 3 parking brake cable as follows.
Remove the clamp bolt (labeled F) from the crossmember.
Remove the clamp bolt (labeled G) from the beam bracket.
Remove the clamp bolt (labeled H) from the beam bracket.