Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
89543
1.INSTALL FRONT SPEED SENSOR LH
To prevent interference with other parts, do not twist the sensor wire's painted line areas when installing it.
Set the sensor body to the knuckle, and then install the sensor with the bolt.
Keep the sensor tip and sensor installation hole free from foreign matter.
Firmly insert the sensor body into the knuckle before tightening the bolt.
After installing the sensor to the knuckle, make sure that there is no clearance between the sensor stay and knuckle. Also make sure that no foreign matter is stuck between the parts.
To prevent interference between the sensor and magnetic rotor, do not rotate the sensor body during or after the insertion of the sensor body to the knuckle.
Install the sensor clamp and sensor clip as follows.
Set the flexible hose clamp on the flexible hose bracket.
Simultaneously perform the following: 1) hang the hook part of the sensor clamp (labeled A) on the flexible hose bracket (labeled C); and 2) insert the hook part of the sensor clamp (labeled B) into the flexible hose bracket (labeled D).
Do not twist the sensor wire when installing the clamp.
Tighten together the sensor clamp, flexible hose clamp and flexible hose bracket with the bolt (labeled E).
Insert the sensor clip (labeled F) into the hole on the absorber lower bracket.
Install the sensor clamp, and sensor clip as follows.
Set the sensor clamp (labeled G) on the side member, and then tighten it with the bolt (labeled H).
Do not twist the sensor wire when installing the clamp.
Insert the sensor clip (labeled I) into the hole on the apron.
Insert the sensor clip (labeled J) into the hole on the apron.
Connect the sensor connector (labeled K).
53876A
2.INSTALL FRONT FENDER LINER LH
3.INSTALL FRONT WHEEL
T = 103 N*m{ 1,050 kgf*cm 76 ft.*lbf }
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
5.CHECK SPEED SENSOR SIGNAL