Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND DECELERATION SENSOR › from 2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292154 YAW RATE AND DECELERATION SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  YAW RATE AND DECELERATION SENSOR  INSTALLATION  


PROCEDURE

Hide 89183A 1.INSTALL YAW RATE SENSOR

a.
C352597

Install the yaw rate sensor with the 2 bolts.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)

NOTICE:
·

Do not damage the yaw rate sensor.

·

Make sure that the yaw rate sensor is installed securely.




b.

Connect the yaw rate sensor connector.


Hide 2.INSTALL FRONT SEAT ASSEMBLY RH

a.

for Manual Seat:

Install the front seat assembly RH (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION).


b.

for Power Seat:

Install the front seat assembly RH (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>INSTALLATION).


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION