Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2013.04–2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292157 ANTI-LOCK BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  C0226/21  SFR Solenoid Circuit  C0236/22  SFL Solenoid Circuit  C0246/23  SRR Solenoid Circuit  C0256/24  SRL Solenoid Circuit  


DESCRIPTION

This solenoid is turned on in accordance with signals from the skid control ECU and controls the pressure on the wheel cylinders to control the braking force.

DTC No. DTC Detection Condition Trouble Area
C0226/21
C0236/22
C0246/23
C0256/24
Solenoid valve signal does not match to the check result. Brake actuator

HINT:

C0226/21, C0236/22, C0246/23, C0256/24:

The skid control ECU begins to detect these DTCs when the vehicle speed exceeds 15 km/h (9 mph).


WIRING DIAGRAM

C137930E02
1.354,1.563 2.094,1.74 0.74,0.177 10 false ABS NO. 2 1.302,4.49 2.021,4.667 0.719,0.177 10 false ABS NO. 1 0.75,5.792 1.094,5.979 0.344,0.188 10 false ALT 0.74,5.188 1.531,5.375 0.792,0.188 10 false F/B ALT 3.177,6.833 3.615,7.021 0.438,0.188 10 false GND1 3.167,7.156 3.604,7.344 0.438,0.188 10 false GND2 3.167,5.594 3.521,5.802 0.354,0.208 10 false +BM 3.156,1.583 3.51,1.792 0.354,0.208 10 false +BS 2.927,1.594 3.094,1.802 0.167,0.208 10 false 3 2.927,5.583 3.094,5.792 0.167,0.208 10 false 2 2.948,6.833 3.115,7.042 0.167,0.208 10 false 4 2.938,7.167 3.104,7.375 0.167,0.208 10 false 1 5.573,5.646 6.396,5.875 0.823,0.229 10 false Motor Relay 5.438,1.656 6.552,1.865 1.115,0.208 10 false Solenoid Relay 5.365,1.052 6.563,1.208 1.198,0.156 10 false Skid Control ECU 3.958,7.823 5.094,8.219 1.135,0.396 10 false A22 0.74,6.354 1.354,6.542 0.615,0.188 10 false FL MAIN 0.865,7.073 1.677,7.26 0.813,0.188 10 false Battery 3.958,8 5.094,8.396 1.135,0.396 10 false Brake Actuator

PROCEDURE

1.RECONFIRM DTC

b.

Start the engine.


c.

Drive the vehicle at 15 km/h (9 mph) or more to activate the initial check.


d.

Check if the same DTC(s) is output (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output B

HINT:

The DTCs may be stored due to a malfunction in the connector terminal.




A

END

B