Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2013.04–2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292157 ANTI-LOCK BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  C1237/37  Speed Sensor Rotor is Wrong Number of Teeth on One of the 4 Wheels  


DESCRIPTION

This DTC is set when there is a tire size abnormality or when foreign matter is attached to the speed sensor tip or the sensor rotor.

The skid control ECU determines whether foreign matter is present, through the pulse signals transmitted by the sensor.

This DTC may be set due to defects in the connector terminal or wire harness of the speed sensor circuit.

DTC No. DTC Detection Condition Trouble Area
C1237/37 When any of following (1 to 3) detected:
1. Discrepancy among four wheel speed sensor output.
2. Abnormal pulse signals from 3 or more sensors.
3. Continuous ABS control for 60 seconds or more.
·

Speed sensor rotor

·

Speed sensor

·

Speed sensor circuit

·

Tire & wheel size



PROCEDURE

1.CHECK TIRE SIZE
a.

Check the diameters of all 4 tires.

OK:

Diameters of all 4 tires are equal.




OK

2.CHECK SPEED SENSOR ROTOR

NG

REPLACE TIRE WITH 4 EQUAL SIZE TIRES

2.CHECK SPEED SENSOR ROTOR
a.

Remove the drive shaft, and check around the speed sensor rotor.

OK:

No scratches or foreign matter on the sensor tip.




OK

3.CHECK SPEED SENSOR

NG

REPLACE SPEED SENSOR ROTOR

3.CHECK SPEED SENSOR
a.

b.


OK

4.CHECK WIRE HARNESS (SKID CONTROL ECU - EACH SPEED SENSOR)

NG

REPLACE SPEED SENSOR

4.CHECK WIRE HARNESS (SKID CONTROL ECU - EACH SPEED SENSOR)
a.

b.


OK

5.RECONFIRM DTC

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.RECONFIRM DTC

b.

Drive the vehicle at more than 20 km/h (12 mph) for more than 60 seconds.


c.

Check if the same DTC(s) is output (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output B



A

END

B