NOTICE FOR INITIALIZATION
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
| System Name | See procedure |
|---|---|
| Lighting System | ( )
|
| Parking Assist Monitor System | |
| Power Slide Door System | |
| Power Back Door System |
TROUBLESHOOTING PRECAUTION
When there are malfunctions in the contact points of the terminals or installation problems with any parts, removal and installation of the suspected problem parts may return the system to its normal condition either entirely or temporarily.
In order to determine the malfunctioning area, be sure to check the conditions at the time the malfunction occurred such as by DTC output and freeze frame data output, and record it before disconnecting each connector or removing and installing parts.
Since the vehicle stability control system may be influenced by malfunctions in other systems, be sure to check for DTCs in the other systems.
Be sure to remove and install the ABS and TRACTION actuator and each sensor with the engine switch off unless specified in the inspection procedures.
When removing and installing the ABS and TRACTION actuator and each sensor, be sure to check that the normal display is output during a test mode inspection and a DTC output inspection after reinstalling all the parts.
The CAN communication system is used for data communication between the skid control ECU, the steering angle sensor and the yaw rate sensor (the deceleration sensor is included). If there is trouble in the CAN communication line, the DTC of the communication line is output.
If the DTC of the CAN communication line is output, repair the malfunction in the communication line and then troubleshoot the vehicle stability control system.
Since a CAN communication line has its own length and route, it cannot be repaired temporarily with a bypass wire, etc.
When replacing the yaw rate sensor and ECM, perform yaw rate sensor zero point calibration first, and then CVT oil pressure calibration (See page Drivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION).