Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2013.04–2014.09
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292158 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C0226/21  SFR Solenoid Circuit  C0236/22  SFL Solenoid Circuit  C0246/23  SRR Solenoid Circuit  C0256/24  SRL Solenoid Circuit  C1225/25  SM Solenoid Circuit  C1226/26  SMC Solenoid Circuit  C1227/27  SRC Solenoid Circuit  C1228/28  SRC Solenoid Circuit  


DESCRIPTION

This solenoid is turned on in accordance with signals from the skid control ECU and controls the pressure on the wheel cylinders to control the braking force.

The solenoid and solenoid relay are built into the ABS and TRACTION actuator.

DTC No. DTC Detection Condition Trouble Area
C0226/21
C0236/22
C0246/23
C0256/24
Solenoid valve signal does not match the check result. ABS and TRACTION actuator
C1225/25
C1226/26
C1227/27
C1228/28
Open or short in SRM or SRC circuit. ABS and TRACTION actuator

HINT:

DTCs C0226/21, C0236/22, C0246/23, C0256/24, C1225/25, C1226/26, C1227/27 and C1228/28:

The skid control ECU begins to detect these DTCs when the vehicle speed exceeds 15 km/h (9 mph).


WIRING DIAGRAM

C204093E02
2.958,1.031 4.115,1.219 1.156,0.188 10 false Skid Control ECU 2.635,3.229 4.583,3.469 1.948,0.24 10 false ABS and TRACTION Actuator

PROCEDURE

1.RECONFIRM DTC

b.

Start the engine.


c.

Drive the vehicle at 15 km/h (9 mph) or more to activate the initial check.


d.

Check if the same DTC(s) is output (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output (for 2AZ-FE) A
DTC is output (for 2GR-FE) B
DTC is not output C

HINT:

The DTCs may be stored due to a malfunction in the connector terminal.




A

B

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY

C

END