1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
28800
2.REMOVE BATTERY
74431
3.REMOVE BATTERY TRAY
17705
4.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17700
5.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
6.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
7.DISCONNECT BRAKE LINES
Using SST, disconnect the 6 brake tubes from the ABS and traction actuator assembly.
Place tags or marks to identify the installation locations of each brake line.
44540
8.REMOVE ABS AND TRACTION ACTUATOR ASSEMBLY WITH BRACKET
Pull the lock lever upward and disconnect the connector.
Disconnect the brake tube clamp from the bracket.
Remove the 3 nuts and ABS and traction actuator assembly with bracket.
Be careful not to damage the brake lines.