Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR(for 2GR-FE) › 2013.04–2014.09
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292161 BRAKE ACTUATOR(for 2GR-FE) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR(for 2GR-FE)  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 2.REMOVE FRONT COWL TOP OUTSIDE PANEL WITH WINDSHIELD WIPER MOTOR LINK

Hide 5.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 6.DISCONNECT BRAKE LINES

a.
C130697

Using SST, disconnect the 6 brake lines from the ABS and traction actuator assembly.

SST
09023-00101  
09023-38201  


b.
C130698E02
1.177,0.531 1.417,0.219 false 1.385,0.917 1.708,0.625 false 1.594,1.219 1.896,1.052 false 1.823,1.521 1.979,1.479 false 2.188,2.875 2.646,4.021 2.646,4.021 2.646,2.667 true 1.458,0.104 2.563,0.281 1.104,0.177 10 false Front Wheel LH 2.031,1.396 3.135,1.573 1.104,0.177 10 false Front Wheel RH 1.938,0.948 3.042,1.125 1.104,0.177 10 false Rear Wheel LH 1.75,0.531 2.854,0.708 1.104,0.177 10 false Rear Wheel RH 2.188,4.063 3.229,4.281 1.042,0.219 10 false Master Cylinder

Place tags or marks to identify the installation locations of each brake line.


Hide 44540 7.REMOVE ABS AND TRACTION ACTUATOR ASSEMBLY WITH BRACKET

a.
C130699

Pull the lock lever upward and disconnect the connector.


b.
C133750

Disconnect the brake tube clamp from the bracket.


c.
C130700

Remove the 3 nuts and actuator with bracket.

NOTICE:

Be careful not to damage the brake lines.