Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2013.04–2014.09
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292158 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1246/46  Master Cylinder Pressure Sensor Malfunction  C1281/81  Master Cylinder Pressure Sensor Output Malfunction (Test Mode DTC)  


DESCRIPTION

The master cylinder pressure sensor is connected to the skid control ECU in the ABS and TRACTION actuator.

DTC C1281/81 can be detected when the master cylinder pressure sensor sends a master cylinder pressure signal or test mode ends. DTC C1281/81 is output only in test mode.

DTC No. DTC Detection Condition Trouble Area
C1246/46 When one of following conditions is met:
·

The voltage of the sensor signal is out of range (less than 0.3 V, more than 4.86 V).

·

The sensor supply voltage is out of range (above 5.3 V, below 4.7 V).

·

The sensor signal offset value is out of range.

·

The sum of signal 1 and signal 2 is out of range (above 5.5 V, below 4.5 V).


·

Master cylinder pressure sensor

·

Master cylinder pressure sensor circuit

·

Stop light switch circuit

·

ABS and TRACTION actuator


C1281/81 Detected only during test mode.
·

Master cylinder pressure sensor

·

Master cylinder pressure sensor circuit

·

Stop light switch circuit

·

ABS and TRACTION actuator



PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SWITCH)
a.

Check the Data List for proper functioning of the stop light switch.

ABS/VSC/TRC
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Stop Light SW Stop light switch / ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released
-

OK:

ON (brake pedal is depressed) appears on the screen.




OK

2.READ VALUE USING INTELLIGENT TESTER (MASTER CYLINDER PRESSURE SENSOR)

NG

CHECK STOP LIGHT SWITCH CIRCUIT

2.READ VALUE USING INTELLIGENT TESTER (MASTER CYLINDER PRESSURE SENSOR)
a.

Check the Data List for proper functioning of the master cylinder pressure sensor.

ABS/VSC/TRC
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Master Cylinder Sensor Master cylinder pressure sensor 1 reading / min.: 0 V, max.: 5 V When brake pedal released: 0.3 to 0.9 V -

OK:

When the pedal is depressed, the sensor output voltage increases.

Result
Result Proceed to
OK A
NG (for 2AZ-FE) B
NG (for 2GR-FE) C




A

3.RECONFIRM DTC

B

C

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY

3.RECONFIRM DTC

b.

Drive the vehicle at a speed of 30 km/h (18 mph) or more and perform a braking test (decelerate the vehicle by depressing the brake pedal).


c.

Check if the same DTC(s) is recorded (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is output (for 2AZ-FE) A
DTC is output (for 2GR-FE) B
DTC is not output C



A

B

REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY

C

END