These DTCs are stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the yaw rate and acceleration sensor.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1419 | Acceleration Sensor Internal Circuit | With the +BS terminal voltage between 9.6 and 16.5 V, an acceleration sensor malfunction signal is received from the acceleration sensor. | Acceleration sensor (yaw rate and acceleration sensor) |
| C1435 | Yaw Rate Sensor Internal Circuit | With the +BS terminal voltage between 9.6 and 16.5 V, a yaw rate sensor malfunction signal is received from the yaw rate sensor. | Yaw rate sensor (yaw rate and acceleration sensor) |
When replacing the yaw rate and acceleration sensor, perform acceleration sensor zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
Replace the yaw rate and acceleration sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND DECELERATION SENSOR>REMOVAL).
Check the yaw rate and acceleration sensor signal after replacement (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>TEST MODE PROCEDURE).
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).
NEXT