Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292158 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1420  Acceleration Sensor Malfunction  


DESCRIPTION

This DTC is stored when the skid control ECU (brake actuator assembly) detects an abnormality in the difference between the acceleration sensor value and the control value estimated based on the yaw rate sensor, steering angle sensor and speed sensor signals.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1420 Acceleration Sensor Malfunction The difference between the acceleration sensor value and the control value estimated inside the skid control ECU (brake actuator assembly) is abnormal.
·

Sensor installation

·

Acceleration sensor (yaw rate and acceleration sensor)



CAUTION / NOTICE / HINT

NOTICE:

When replacing the yaw rate and acceleration sensor, perform acceleration sensor zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION
a.

Check that the yaw rate and acceleration sensor has been installed properly (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND DECELERATION SENSOR>INSTALLATION).

OK:

The yaw rate and acceleration sensor is tightened to the specified torque.

The yaw rate and acceleration sensor is not installed in a tilted position.


HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).




OK

NG

INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY