This DTC is stored when the skid control ECU (brake actuator assembly) detects improper installation of the yaw rate and acceleration sensor or an abnormality in the difference between the yaw rate sensor value and the control value estimated based on the acceleration sensor, steering angle sensor and speed sensor signals.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1436 | Yaw Rate Sensor Malfunction | Difference between the yaw rate sensor value and the control value estimated inside the skid control ECU (brake actuator assembly) is abnormal. | ·
Sensor installation ·
Yaw rate sensor (yaw rate and acceleration sensor) |
When replacing the yaw rate and acceleration sensor, perform acceleration sensor zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Select the Data List using the GTS (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Yaw Rate Sensor | Yaw rate sensor / Min.: -128 °/s, Max.: 127 °/s | Vehicle stopped: 0 °/s
Turning right: -128 to 0 °/s Turning left: 0 to 127 °/s |
- |
Check the yaw rate and acceleration sensor output value displayed on the GTS.
| Result | Proceed to |
|---|---|
| NG (The yaw rate and acceleration sensor output value is 0 °/s when the vehicle is stationary, but the value fluctuates when turning.) | A |
| NG (The yaw rate and acceleration sensor output value is not 0 °/s when the vehicle is stationary.) | B |
| OK | C |
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).
A
B
C
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
Turn the engine switch off.
Drive the vehicle straight ahead at 50 km/h (31 mph) or more for at least 30 seconds.
Check that the steering wheel is correctly centered while driving straight ahead.
If front wheel alignment and steering are adjusted as a result of an off-center steering wheel, acquire the yaw rate and acceleration sensor zero point again after the adjustments are completed.
The steering wheel is correctly centered.
OK
NG
Check that the yaw rate and acceleration sensor has been installed properly (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND DECELERATION SENSOR>INSTALLATION).
The yaw rate and acceleration sensor is tightened to the specified torque.
The yaw rate and acceleration sensor is not installed in a tilted position.
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).
OK
NG
(See pageBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND DECELERATION SENSOR>INSTALLATION)