The skid control ECU (brake actuator assembly) receives engine speed signals from the ECM via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1224 | NE Signal | The vehicle speed is 6 km/h (4 mph) or more, the +BS terminal voltage is between 9.6 and 16.5 V, and the engine speed signal is more than 12800 rpm for 2.5 seconds or more. | ·
CAN communication system ·
ECM |
Check if CAN communication system DTCs are output (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
A
B
Check if SFI system DTCs are output (See page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR for 2AZ-FE, Engine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR for 2GR-FE).
| Result | Proceed to |
|---|---|
| DTCs are not output (for 2AZ-FE). | A |
| DTCs are not output (for 2GR-FE). | B |
| DTCs are output (for 2AZ-FE). | C |
| DTCs are output (for 2GR-FE). | D |
A
B
C
(See pageEngine / Hybrid System>2AZ-FE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
D
(See pageEngine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)