Home › Vehicle Interior › AIR CONDITIONING › REAR COOLER RELAY
RM24M0E _58 Vehicle Interior _059584 AIR CONDITIONING _0292178 REAR COOLER RELAY G

AIR CONDITIONING  REAR COOLER RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 88630Y 2.REMOVE REAR COOLER RELAY

a.

Remove the rear cooling unit (see page Vehicle Interior>AIR CONDITIONING>REAR COOLING UNIT>REMOVAL).


b.
E133844

Remove the rear cooler relay from the rear cooling unit.


Hide 3.INSPECT REAR COOLER RELAY

B083458E09
2.104,1.708 2.104,1.188 false 2.479,1.698 2.479,1.51 false 2.479,0.635 2.479,0.833 false 2.802,0.573 2.823,0.99 false 2.938,1.698 2.531,1.156 false 2.771,0.396 2.917,0.583 0.146,0.188 10 false 5 2.427,0.438 2.573,0.625 0.146,0.188 10 false 1 2.938,1.656 3.083,1.844 0.146,0.188 10 false 4 1.396,0.729 1.542,0.917 0.146,0.188 10 false 3 2.438,1.75 2.583,1.938 0.146,0.188 10 false 2 0.365,0.75 0.51,0.938 0.146,0.188 10 false 5 0.375,1.552 0.521,1.74 0.146,0.188 10 false 1 0.896,0.063 1.042,0.25 0.146,0.188 10 false 4 2.063,1.75 2.208,1.938 0.146,0.188 10 false 3 1.396,1.583 1.542,1.771 0.146,0.188 10 false 2

a.

Measure the resistance of the relay.

Standard resistance:
Tester Connection Specified Condition
3 - 4 Below 1 Ω
3 - 5 10 kΩ or higher
3 - 4 10 kΩ or higher
(when battery voltage is applied to terminals 1 and 2)
3 - 5 Below 1 Ω
(when battery voltage is applied to terminals 1 and 2)


If the result is not as specified, replace the relay.



Hide 88630Y 4.INSTALL REAR COOLER RELAY

a.

Install the rear cooler relay to the rear cooling unit.


b.

Install the rear cooling unit (see page Vehicle Interior>AIR CONDITIONING>REAR COOLING UNIT>INSTALLATION).


Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 6.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.