Home › Vehicle Interior › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM
RM24M0E _58 Vehicle Interior _059586 ENGINE IMMOBILISER _0292196 ENGINE IMMOBILISER SYSTEM L

ENGINE IMMOBILISER  ENGINE IMMOBILISER SYSTEM  PRECAUTION  


NOTICE FOR INITIALIZATION


NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.


System Name See procedure
Lighting System (Click here)
Parking Assist Monitor System
Power Slide Door System
Power Back Door System


PRECAUTIONS WHEN USING INTELLIGENT TESTER


a.

When using the intelligent tester to troubleshoot the LIN communication line:

Connect the intelligent tester to the vehicle, and turn a courtesy light switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.


b.

After all DTCs are cleared, check if the trouble occurs again 6 seconds after the engine switch is turned on (IG).



PRECAUTIONS FOR EACH FUNCTION


a.

Precautions for the key:

The key is a precision instrument. Be sure to observe the following:

·

Do not drop or strike the key.

·

Do not keep the key in a high temperature area for a long time.

·

Do not use an ultrasonic washing machine to clean the key.

·

Keep the key away from magnets or magnetized items during use.

·

Do not attach any stickers to the key.



b.

Precaution for the engine start function:

i.

Before starting the engine, firmly depress the clutch pedal*1 (brake pedal*2) until the indicator of the engine switch illuminates in green.

HINT:

*1: for M/T

*2: for A/T



ii.

Be sure to turn the engine switch off before disconnecting the cable from the negative (-) battery terminal. When the battery cable is disconnected, the power source mode (off, on (ACC), on (IG)) is memorized. When battery depletion causes the vehicle's power to be cut, be sure to remember the power source mode.


iii.

After the battery is removed and reinstalled, be sure to wait 10 seconds or more before the next engine start. The engine may not start immediately after the battery is reinstalled.


iv.

When the key battery is depleted and it is held close to the engine switch to start the engine, several warnings may sound. However, the warnings most likely sound because the vehicle cannot determine if the key is in the vehicle or not, and not because there is an actual malfunction. The following warnings may sound:

- Driver side door open → closed:

·

Warning to inform that the shift lever is in a position other than P, and the power source mode is not off.

·

Warning to inform that the shift lever is in P but the power source mode is not off.


- Door other than the driver side door open → closed:

·

Warning to inform that a passenger is carrying the key out of the vehicle.




c.

Precautions for the battery built into the key and the vehicle battery:

i.

When the door is being locked, the vehicle battery is used to transmit a radio wave. The battery may become depleted if the vehicle remains stopped for a long time. If the vehicle is not used for a long time, recharge or replace the battery or cancel the smart entry and start system*1 or push-button start*2.

·

*1: w/ Smart Entry and Start System

·

*2: w/ Push-button Start



ii.

When the door is being locked with the key in the detection area of the door oscillator, the battery is used to regulate communication between the key and vehicle. If the vehicle is not used, keep the key away from the vehicle (more than 2 m (6.56 ft.)).




PRECAUTION FOR CERTIFICATION ECU


NOTICE:

If the certification ECU and/or steering lock actuator (steering lock ECU) are replaced, open and close the driver side door to record the current steering lock position into the certification ECU. If this is not performed, the engine may not start.