The combination meter sub-assembly controls the speedometer in accordance with vehicle speed signals from the brake actuator assembly (skid control ECU) through the CAN communication system.
If DTC U0129 has been stored, troubleshoot the CAN communication system first.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Speed Meter Operation | Speedometer | 0 / 40 / 80 / 120 / 160 / 200 km | Value selected during ACTIVE TEST is displayed
There is a deviation in the values displayed on the speedometer (Control range → Speedometer display) Reference (for 2GR-FE RHD or 2AZ-FE RHD without Entry Function) ·
40 km/h → 40.6 to 45.4 km/h ·
80 km/h → 81.3 to 86.3 km/h ·
120 km/h → 121.9 to 127.1 km/h ·
160 km/h → 162.6 to 168.3 km/h ·
200 km/h → 203.2 to 210.0 km/h Reference (except 2GR-FE RHD or 2AZ-FE RHD without Entry Function) ·
40 km/h → 41.7 to 46.2 km/h ·
80 km/h → 83.4 to 88.4 km/h ·
120 km/h → 125.1 to 130.6 km/h ·
160 km/h → 166.2 to 173.2 km/h ·
200 km/h → 207.7 to 215.7 km/h |
Vehicle speed displayed on the GTS is almost the same as that of the speedometer reading.
OK
NG
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Data List.
Read the Data List according to the display on the GTS.
| Item | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Vehicle Speed Meter | Vehicle speed / Min.: 0 km/h, Max.: 255 km/h | Almost same as actual vehicle speed (when driving) | - |
Almost same as actual vehicle speed (when driving).
OK
NG