1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55420A
3.REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER ASSEMBLY
4.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET
Remove the 4 screws.
Disconnect each connector and remove the navigation receiver assembly with bracket.
86211J
5.REMOVE NO. 1 RADIO RECEIVER BRACKET
Remove the 4 screws and No. 1 radio receiver bracket.
86212C
6.REMOVE NO. 2 RADIO RECEIVER BRACKET
Remove the 4 screws and No. 2 radio receiver bracket.
86120L
7.REMOVE NAVIGATION RECEIVER ASSEMBLY