1.INSTALL FRONT BUMPER ASSEMBLY
Connect each connector.
Engage the 6 claws and install the front bumper assembly as shown in the illustration.
Install the 4 bolts and 5 screws.
Install the 7 clips.
Install the pin hold clip as shown in the illustration.
| *1 | Correct |
| *2 | Incorrect |
Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.
Use the same procedure for the RH side and LH side.
53101
2.INSTALL RADIATOR GRILLE SUB-ASSEMBLY
Engage the 6 claws to install the radiator grille sub-assembly.
Install the 2 screw and clip.
53292A
3.INSTALL UPPER RADIATOR SUPPORT SEAL
4.ADJUST FOG LIGHT ASSEMBLY