The front corner ultrasonic sensor (LH) is installed on the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front corner ultrasonic sensor (LH). If the front corner ultrasonic sensor (LH) has an open circuit or other malfunction, it will not function normally.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1AE1 | A malfunction of the front corner ultrasonic sensor (LH) | ·
Front corner ultrasonic sensor (LH) ·
Clearance warning ECU assembly |
If DTCs are output after repairs, turn the engine switch on (IG) and turn the clearance sonar main switch (combination switch assembly) on. Then clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for RHD)>DTC CHECK / CLEAR).
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for RHD)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| Only DTC C1AE1 is output | A |
| DTC C1AE1 and C1AEC are output | B |
| No DTCs are output | C |
A
B
C
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
Replace the front corner ultrasonic sensor (LH) with a known good one (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front Side)>REMOVAL).
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
NEXT
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for RHD)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1AE1 is output | A |
| No DTCs are output | B |
A
B