1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55420A
3.REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER ASSEMBLY (for LHD)
55414A
4.REMOVE INSTRUMENT CLUSTER FINISH PANEL END (for LHD)
w/o Navigation System: (See page Vehicle Interior>INTERIOR PANEL>UPPER INSTRUMENT PANEL>REMOVAL)
33504F
5.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for RHD)
for U241E: (See page Drivetrain>U241E (AUTOMATIC TRANSMISSION / TRANSAXLE)>SHIFT LEVER(for RHD)>REMOVAL)
for U660E: (See page Drivetrain>U660E (AUTOMATIC TRANSMISSION / TRANSAXLE)>SHIFT LEVER(for RHD)>REMOVAL)
for K112: (See page Drivetrain>K112 (CVT)>SHIFT LEVER(for RHD)>REMOVAL)
6.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for RHD)
55414A
7.REMOVE INSTRUMENT CLUSTER FINISH PANEL END (for RHD)
55522B
8.REMOVE RADIO TUNER OPENING COVER (w/o Radio Receiver)
9.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)
10.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for Navigation Receiver Type)
55041B
11.REMOVE NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY (for RHD)
55660
12.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY (for LHD)
55042B
13.REMOVE NO. 2 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY (for LHD)
55042B
14.REMOVE NO. 2 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY (for RHD)
55550
15.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
89340A
16.REMOVE CLEARANCE WARNING ECU
Disconnect the connector.
Remove the screw and ECU.