Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM(for RHD) › from 2016.05
RM24M0E _56 Audio / Visual / Telematics _059590 PARK ASSIST / MONITORING _0292210 TOYOTA PARKING ASSIST-SENSOR SYSTEM(for RHD) C

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(for RHD)  C1AEC  Front Sensor Communication Malfunction  


DESCRIPTION

This DTC is stored when there is an open or short circuit in the communication line between the front sensors and the clearance warning ECU assembly, or when there is a malfunction in a front sensor.

DTC No. DTC Detection Condition Trouble Area
C1AEC An open or short circuit in the communication line between the front sensors and clearance warning ECU assembly or a malfunction in a front sensor during initialization mode after the engine switch is turned on (IG).
·

Front sensor circuit

·

Clearance warning ECU assembly



WIRING DIAGRAM

E231492E75
0.229,1.917 1.792,2.385 1.563,0.469 10 false Front Corner Ultrasonic Sensor (RH) 2.865,1.917 4.51,2.354 1.646,0.438 10 false Front Corner Ultrasonic Sensor (LH) 5.667,1.917 6.854,2.313 1.188,0.396 10 false Clearance Warning ECU Assembly 0.219,1.76 0.521,1.906 0.302,0.146 10 false C7 2.854,1.76 3.125,1.906 0.271,0.146 10 false C8 5.667,1.76 5.969,1.906 0.302,0.146 10 false G111 1.219,0.49 1.438,0.635 0.219,0.146 10 false BI 1.219,1.385 1.438,1.531 0.219,0.146 10 false EI 1.219,0.938 1.438,1.083 0.219,0.146 10 false SI 3.906,0.49 4.125,0.635 0.219,0.146 10 false BI 3.906,1.385 4.125,1.531 0.219,0.146 10 false EI 3.906,0.938 4.125,1.083 0.219,0.146 10 false SI 3.156,0.49 3.448,0.635 0.292,0.146 10 false BO 3.156,1.385 3.448,1.531 0.292,0.146 10 false EO 3.156,0.938 3.448,1.083 0.292,0.146 10 false SO 5.823,0.49 6.167,0.635 0.344,0.146 10 false BOF 5.823,1.385 6.052,1.531 0.229,0.146 10 false E5 5.823,0.938 6.167,1.083 0.344,0.146 10 false SOF 1.469,0.406 1.604,0.552 0.135,0.146 10 false 1 1.469,0.844 1.604,0.99 0.135,0.146 10 false 3 1.469,1.302 1.583,1.448 0.115,0.146 10 false 5 4.135,0.406 4.25,0.552 0.115,0.146 10 false 1 4.135,0.844 4.25,0.99 0.115,0.146 10 false 3 4.135,1.302 4.25,1.448 0.115,0.146 10 false 5 2.99,0.396 3.104,0.542 0.115,0.146 10 false 2 2.99,0.854 3.104,1 0.115,0.146 10 false 4 2.99,1.302 3.104,1.448 0.115,0.146 10 false 6 5.573,0.396 5.75,0.542 0.177,0.146 10 false 4 5.573,0.844 5.781,0.99 0.208,0.146 10 false 8 5.573,1.302 5.771,1.448 0.198,0.146 10 false 6

PROCEDURE

1.CHECK DTC OUTPUT (C1AEC)

A

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - FRONT CORNER ULTRASONIC SENSOR (LH))

B

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - FRONT CORNER ULTRASONIC SENSOR (LH))
a.

Disconnect the G111 clearance warning ECU assembly connector.


b.

Disconnect the C8 front corner ultrasonic sensor (LH) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G111-4 (BOF) - C8-1 (BI) Always Below 1 Ω
G111-8 (SOF) - C8-3 (SI) Always Below 1 Ω
G111-6 (E5) - C8-5 (EI) Always Below 1 Ω
G111-4 (BOF) - Body ground Always 10 kΩ or higher
G111-8 (SOF) - Body ground Always 10 kΩ or higher
G111-6 (E5) - Body ground Always 10 kΩ or higher




OK

3.CHECK HARNESS AND CONNECTOR (FRONT CORNER ULTRASONIC SENSOR (LH) - FRONT CORNER ULTRASONIC SENSOR (RH))

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (FRONT CORNER ULTRASONIC SENSOR (LH) - FRONT CORNER ULTRASONIC SENSOR (RH))
a.

Disconnect the C7 front corner ultrasonic sensor (RH) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C8-2 (BO) - C7-1 (BI) Always Below 1 Ω
C8-4 (SO) - C7-3 (SI) Always Below 1 Ω
C8-6 (EO) - C7-5 (EI) Always Below 1 Ω
C8-2 (BO) - Body ground Always 10 kΩ or higher
C8-4 (SO) - Body ground Always 10 kΩ or higher
C8-6 (EO) - Body ground Always 10 kΩ or higher




OK

4.INSPECT FRONT CORNER ULTRASONIC SENSOR (LH)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT FRONT CORNER ULTRASONIC SENSOR (LH)
a.
E270573E05
1.958,0.896 2.375,0.479 false 1.958,1.115 2.656,1.115 false 1.958,1.365 2.417,1.74 false 0.948,0.563 1.5,0.896 false 0.823,1.115 1.5,1.115 false 1.021,1.75 1.479,1.354 false 2.729,1.031 3.042,1.229 0.313,0.198 10 false SI 2.479,0.375 2.792,0.573 0.313,0.198 10 false BI 2.51,1.667 2.823,1.865 0.313,0.198 10 false EI 0.552,1.052 0.865,1.25 0.313,0.198 10 false SO 0.615,0.458 0.927,0.656 0.313,0.198 10 false BO 0.771,1.698 1.083,1.896 0.313,0.198 10 false EO 0.115,0.115 0.427,0.313 0.313,0.198 10 false *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (BI) - 5 (EI) Always 10 kΩ or higher
1 (BI) - 2 (BO) Always 10 kΩ or higher
3 (SI) - 4 (SO) Always Below 1 Ω
5 (EI) - 6 (EO) Always Below 1 Ω


Text in Illustration
*a Component without harness connected
Front Corner Ultrasonic Sensor (LH))



OK

5.REPLACE FRONT CORNER ULTRASONIC SENSOR (RH)

NG

5.REPLACE FRONT CORNER ULTRASONIC SENSOR (RH)

NEXT

6.CHECK DTC OUTPUT (C1AEC)
6.CHECK DTC OUTPUT (C1AEC)

A

7.REPLACE FRONT CORNER ULTRASONIC SENSOR (LH)

B

END (FRONT CORNER ULTRASONIC SENSOR (RH) WAS DEFECTIVE)

7.REPLACE FRONT CORNER ULTRASONIC SENSOR (LH)

NEXT

8.CHECK DTC OUTPUT (C1AEC)
8.CHECK DTC OUTPUT (C1AEC)

A

B

END (FRONT CORNER ULTRASONIC SENSOR (LH) WAS DEFECTIVE)