Home › Vehicle Interior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM › from 2016.05
RM24M0E _58 Vehicle Interior _059592 WINDOW / GLASS _0292216 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  All Power Windows do not Operate with Driver Side Door Key Cylinder or Wireless Transmitter  


DESCRIPTION

·

When a key switch is pushed: 1) the door control receiver receives the key signal; 2) the door control receiver sends a signal to the certification ECU; 3) the main body ECU sends the operation permission signal to the power window regulator motor assembly; and 4) the power window regulator motor assemblies are activated.

·

When the driver door key cylinder (key linked switch) is turned: 1) the door lock motor receives the signal; 2) the main body ECU sends the signal to the power window regulator motor assembly; and 3) the power window regulator motor assemblies are activated.


HINT:

This function is set through the customize function, as it is off by default.


CAUTION / NOTICE / HINT

NOTICE:

The power window control system use LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (See page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING). Troubleshoot the power window control system after confirming that the communication system is functioning properly.


PROCEDURE

1.CHECK BASIC FUNCTION (WIRELESS AND POWER DOOR LOCK CONTROL SYSTEM)
a.

Check that the electrical key transmitter (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM>OPERATION CHECK) and driver door key cylinder (key linked switch) (See page Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>OPERATION CHECK) lock and unlock all the doors normally.

Result:
Result Proceed to
Electrical key transmitter and driver door key cylinder operate normally A
Electrical key transmitter does not operate normally B
Driver door key cylinder does not operate normally C




A

2.CHECK MANUAL UP / DOWN FUNCTION

B

GO TO WIRELESS DOOR LOCK CONTROL SYSTEM (Proceed to Problem Symptoms Table)

C

GO TO POWER DOOR LOCK CONTROL SYSTEM (Proceed to Problem Symptoms Table)

2.CHECK MANUAL UP / DOWN FUNCTION
a.

Check that the manual up/down function using the multiplex network master switch assembly and power window regulator switch assembly can operate all the power windows (See page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

OK:

Manual up/down function is normal.




OK

3.CHECK REMOTE UP / DOWN FUNCTION

NG

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table)

3.CHECK REMOTE UP / DOWN FUNCTION
a.

Check that the remote up/down function using the multiplex network master switch assembly operates the power windows (See page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

OK:

Remote up/down function is normal.




OK

REPLACE MAIN BODY ECU

NG

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table)