Use these procedures to troubleshoot the power window control system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Using the intelligent tester, inspect the CAN communication function to ensure there are no malfunctions in the communication system.
| Result | Proceed to |
|---|---|
| No DTCs output | A |
| DTCs output | B |
A
B
Using the intelligent tester, inspect the LIN communication function to ensure there are no malfunctions in the communication system.
| Result | Proceed to |
|---|---|
| No DTCs output | A |
| DTCs output | B |
A
B
| Result | Proceed to |
|---|---|
| Fault not listed in problem symptoms table | A |
| Fault listed in problem symptoms table | B |
A
B
Operation Check (See page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).
Terminals of ECU (See page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>TERMINALS OF ECU).
Data List / Active Test (See page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DATA LIST / ACTIVE TEST).
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
If the power window master switch AUTO light is blinking, reset the power window motor (See page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
| Proceed to |
|---|
| NEXT |
NEXT