Home › Vehicle Interior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM › from 2016.05
RM24M0E _58 Vehicle Interior _059592 WINDOW / GLASS _0292216 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  All Power Window Up Functions do not Operate with Entry Lock Switch  


DESCRIPTION

When an entry lock switch is pressed and held for approximately 3 seconds: 1) the certification ECU receives a switch signal, 2) the certification ECU transmits a signal to all the power window regulator motors by multiplex communication, and 3) all the power window motors are operated to close the windows.

HINT:

This function is set through the customize function, as it is off by default.


CAUTION / NOTICE / HINT

NOTICE:

The power window control system use LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (See page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING). Troubleshoot the power window control system after confirming that the communication system is functioning properly.


PROCEDURE

1.CHECK BASIC FUNCTION (SMART ENTRY AND START SYSTEM (FOR ENTRY FUNCTION))
a.

Check that the entry lock switch operates normally (See page Vehicle Interior>DOOR LOCK>SMART ENTRY AND START SYSTEM>OPERATION CHECK).

OK:

Entry lock switch operates normally.




OK

2.CHECK MANUAL UP / DOWN FUNCTION

NG

GO TO SMART ENTRY AND START SYSTEM (FOR ENTRY FUNCTION) (Proceed to Problem Symptoms Table for Each Door)

2.CHECK MANUAL UP / DOWN FUNCTION
a.

Check that the manual up/down function using the multiplex network master switch assembly and power window regulator switch assembly can operate all the power windows (See page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

OK:

Manual up/down function is normal.




OK

3.CHECK REMOTE UP / DOWN FUNCTION

NG

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table)

3.CHECK REMOTE UP / DOWN FUNCTION
a.

Check that the remote up/down function using the multiplex network master switch assembly operates the power windows (See page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).

OK:

Remote up/down function is normal.




OK

REPLACE MAIN BODY ECU

NG

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table)