52156B
1.INSTALL REAR NO. 2 BUMPER SIDE SUPPORT LH
Engage the 2 claws to install the side retainer.
Install the 2 screws.
52156A
2.INSTALL REAR BUMPER SIDE SUPPORT LH
Engage the 3 claws to install the side retainer.
Install the 2 screws.
52155B
3.INSTALL REAR NO. 2 BUMPER SIDE SUPPORT RH
Use the same procedure as for the LH side.
52155A
4.INSTALL REAR BUMPER SIDE SUPPORT RH
Use the same procedure as for the LH side.
81920
5.INSTALL REFLEX REFLECTOR ASSEMBLY LH
Install the reflex reflector with the screw.
81910
6.INSTALL REFLEX REFLECTOR ASSEMBLY RH
Use the same procedure as for the LH side.
81210R
7.INSTALL REAR FOG LIGHT ASSEMBLY (w/ Rear Fog Light)
52616
8.INSTALL REAR BUMPER ENERGY ABSORBER LH
Clean the rear bumper cover.
Remove any remaining double-sided tape from the rear bumper cover.
Wipe off any tape adhesive residue with cleaner.
Remove the release paper from a new rear bumper energy absorber LH.
After removing the release paper, keep the exposed adhesive free from foreign matter.
Install the rear bumper energy absorber LH as shown in the illustration.
| *a | Double-sided Tape |
Press the rear bumper energy absorber LH firmly to install it.
52615
9.INSTALL REAR BUMPER ENERGY ABSORBER RH
Clean the rear bumper cover.
Remove any remaining double-sided tape from the rear bumper cover.
Wipe off any tape adhesive residue with cleaner.
Remove the release paper from a new rear bumper energy absorber RH.
After removing the release paper, keep the exposed adhesive free from foreign matter.
Install the rear bumper energy absorber RH as shown in the illustration.
| *a | Double-sided Tape |
Press the rear bumper energy absorber RH to install it.
52169C
10.INSTALL LOWER REAR BUMPER COVER (for Sport Package)
Engage the claw.
Install the lower rear bumper cover with the clip.
52164A
11.INSTALL REAR BUMPER PLATE LH (for Standard)
Engage the 2 claws to install the rear bumper plate LH.
52163A
12.INSTALL REAR BUMPER PLATE RH (for Standard)
Use the same procedure as for the LH side.
52162B
13.INSTALL NO. 1 REAR BUMPER PLATE (for Sport Package)
Engage the 2 claws to install the No. 1 rear bumper plate.
Use the same procedure for the RH side and LH side.
82182
14.INSTALL NO. 2 LUGGAGE ROOM WIRE (w/ Clearance Sonar System)
Engage the 6 clamps to install the No. 4 engine room wire.
89342A
15.INSTALL REAR CENTER ULTRASONIC SENSOR (w/ Clearance Sonar System)
for Back Sensor: (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Rear Side)>INSTALLATION)
89342
16.INSTALL REAR CORNER ULTRASONIC SENSOR (w/ Clearance Sonar System)
for Corner Sensor: (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Rear Side)>INSTALLATION)
89348D
17.INSTALL ULTRASONIC SENSOR CLIP (w/ Clearance Sonar System)
for Corner Sensor: (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Rear Side)>INSTALLATION)