Home › Vehicle Interior › SLIDING ROOF › SLIDING ROOF SYSTEM
RM24M0E _58 Vehicle Interior _059597 SLIDING ROOF _0292254 SLIDING ROOF SYSTEM C

SLIDING ROOF  SLIDING ROOF SYSTEM  B2341  Sensor (Motor) Failure  B2344  Position Failure  


DESCRIPTION

When the sliding roof drive gear (rear sunshade control ECU) detects a motor malfunction, and the sliding roof operation is stopped, DTC B2341 is output. When the sliding roof drive gear (rear sunshade control ECU) detects a gear malfunction, and the sliding roof operation is stopped, DTC B2344 is output.

DTC No. DTC Detection Condition Trouble Area
B2341 Sensor (motor) failure
·

Sliding roof drive gear (Rear sunshade control ECU)

·

Power slide door control switch (Front sliding roof control switch)

·

Wire harness


B2344 Position failure
·

Sliding roof drive gear (Rear sunshade control ECU)

·

Power slide door control switch (Front sliding roof control switch)

·

Wire harness



WIRING DIAGRAM

B143784E06
1.606,1.805 3.789,2.142 2.184,0.336 10 Power Slide Door Control Switch (Front Sliding Roof Control Switch) 1.595,1.669 1.893,1.818 0.298,0.149 10 Q16 3.606,1.403 3.810,1.604 0.205,0.201 10 8 3.585,0.576 3.730,0.774 0.145,0.198 10 3 5.427,1.403 5.631,1.604 0.205,0.201 10 9 5.406,0.576 5.551,0.774 0.145,0.198 10 7 5.652,1.284 6.027,1.443 0.375,0.159 10 CLS 3.154,0.534 3.528,0.693 0.375,0.159 10 OPN 3.154,1.368 3.528,1.527 0.375,0.159 10 CLS 5.652,0.45 6.027,0.609 0.375,0.159 10 OPN 1.973,0.555 2.122,0.721 0.149,0.166 10 E 1.76,0.58 1.916,0.735 0.156,0.156 10 7 5.23,2.033 7.147,2.358 1.917,0.325 10 Sliding Roof Drive Gear (Rear Sunshade Control ECU) 5.272,1.89 5.492,2.036 0.221,0.147 10 N2

PROCEDURE

1.CHECK SLIDING ROOF FUNCTION
a.

Check the auto operation with the sliding roof control switch (see page Vehicle Interior>SLIDING ROOF>SLIDING ROOF SYSTEM>OPERATION CHECK).

OK:

Auto operation operates normally with sliding roof control switch.




OK

2.DELETE DTC

NG

3.INITIALIZE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (REAR SUNSHADE CONTROL ECU)
2.DELETE DTC

NEXT

END

3.INITIALIZE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (REAR SUNSHADE CONTROL ECU)
a.

Check that the sliding roof drive gear can be initialized (see page Vehicle Interior>SLIDING ROOF>SLIDING ROOF SYSTEM>INITIALIZATION).

OK:

Sliding roof drive gear can be initialized.




OK

4.CHECK SLIDING ROOF FUNCTION

NG

6.CHECK WIRE HARNESS (POWER SLIDE DOOR CONTROL SWITCH - SLIDING ROOF DRIVE GEAR AND BODY GROUND)
4.CHECK SLIDING ROOF FUNCTION
a.

Check the auto operation with the sliding roof control switch (see page Vehicle Interior>SLIDING ROOF>SLIDING ROOF SYSTEM>OPERATION CHECK).

OK:

Auto operation operates normally with sliding roof control switch.




OK

5.DELETE DTC

NG

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (REAR SUNSHADE CONTROL ECU)

5.DELETE DTC

NEXT

END

6.CHECK WIRE HARNESS (POWER SLIDE DOOR CONTROL SWITCH - SLIDING ROOF DRIVE GEAR AND BODY GROUND)
a.

Disconnect the Q16 switch connector.


b.

Disconnect the N2 gear connector.


c.

Measure the resistance of the wire harness side connectors.

Standard resistance:
Tester Connection Specified Condition
Q16-3 (OPN) - N2-7 (OPN) Below 1 Ω
Q16-8 (CLS) - N2-9 (CLS) Below 1 Ω
Q16-7 (E) - Body ground Below 1 Ω
Q16-3 (OPN) - Body ground 10 kΩ or higher
Q16-8 (CLS) - Body ground 10 kΩ or higher




OK

7.INSPECT POWER SLIDE DOOR CONTROL SWITCH (FRONT SLIDING ROOF CONTROL SWITCH)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

7.INSPECT POWER SLIDE DOOR CONTROL SWITCH (FRONT SLIDING ROOF CONTROL SWITCH)
B135700E02
2.87,3.706 3.211,3.850 0.341,0.144 10 OPN 0.268,4.403 0.568,4.547 0.299,0.144 10 CLS 0.34,3.688 0.468,3.830 0.128,0.142 10 E 0.608,4.476 1.012,4.164 false 0.499,3.776 1.178,4.033 false 2.054,3.999 2.849,3.784 false

a.

Remove the map light.


b.

Measure the resistance of the switch.

Standard resistance:
Tester Connection Condition Specified Condition
3 (OPN) - 7 (E) Front sliding roof control switch is OPEN Below 1 Ω
8 (CLS) - 7 (E) Front sliding roof control switch is CLOSE Below 1 Ω
3 (OPN) - 7 (E)
8 (CLS) - 7 (E)
Front sliding roof control switch is OFF 10 kΩ or higher




OK

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (REAR SUNSHADE CONTROL ECU)

NG

REPLACE POWER SLIDE DOOR CONTROL SWITCH (FRONT SLIDING ROOF CONTROL SWITCH)