NOTICE FOR INITIALIZATION
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
| System Name | See procedure |
|---|---|
| Power Slide Door System | ( )
|
| Power Back Door System | |
| Parking Assist Monitor System | |
| Lighting System (w/ AFS) |
STEERING SYSTEM HANDLING PRECAUTIONS
Care must be taken when replacing parts. Incorrect replacement could affect the performance of the steering system and result in hazards when driving.
SRS AIRBAG SYSTEM HANDLING PRECAUTIONS
This vehicle is equipped with an SRS (Supplemental Restraint System) such as the driver airbag and front passenger airbag. Failure to carry out service operations in the correct sequence could cause unexpected SRS deployment during servicing and may lead to a serious accident. Before servicing (including installation / removal, inspection and replacement of parts), be sure to read the precautionary notice for the Supplemental Restraint System (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
BUS LINE REPAIR
After repairing the bus line with solder, wrap the repaired part with vinyl tape (see page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>ELECTRONIC CIRCUIT INSPECTION PROCEDURE).
The CANL bus line and CANH bus line must be installed together.
When installing, twist them together.
CAN bus lines are likely to be influenced by noise if the bus lines are not twist together.
The difference in length between the CANL bus line and CANH bus line should be less than 100 mm (3.937 in.).
Leave approximately 80 mm (3.150 in.) loose in the twisted wires around the connectors.
Do not use by-pass wiring between the connectors.
The feature of the twisted wire harness will be lost if bypass wiring is used.
CONNECTOR HANDLING
When inserting tester probes into a connector, insert them from the rear of the connector.
Use a repair wire to check the connector if it is impossible to check resistance from the rear of the connector.