Use these procedures to troubleshoot the electronic power steering system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTC (See page Steering>POWER STEERING>POWER STEERING SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| CAN system DTC is not output | A |
| CAN system DTC is output | B |
When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.
When communication to the power steering ECU is not established through the intelligent tester, inspect terminals SIL of the DLC3 and the power steering ECU, and the IG circuit of the power steering ECU.
A
B
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
B
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Terminals of ECU (See page Steering>POWER STEERING>POWER STEERING SYSTEM>TERMINALS OF ECU).
Data List / Active Test (See page Steering>POWER STEERING>POWER STEERING SYSTEM>DATA LIST / ACTIVE TEST).
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT