Use these procedures to troubleshoot the theft deterrent system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Use the intelligent tester to check if the CAN Communication System is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output | B |
A
B
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Data List / Active Test (See page Vehicle Interior>THEFT DETERRENT>THEFT DETERRENT SYSTEM>DATA LIST / ACTIVE TEST)
Terminals of ECU (See page Vehicle Interior>THEFT DETERRENT>THEFT DETERRENT SYSTEM>TERMINALS OF ECU)
On-vehicle Inspection (See page Vehicle Interior>THEFT DETERRENT>THEFT DETERRENT SYSTEM>ON-VEHICLE INSPECTION)
Inspection
Engine hood courtesy switch (See page Vehicle Interior>THEFT DETERRENT>ENGINE HOOD COURTESY SWITCH>INSPECTION)
Security horn assembly (See page Vehicle Interior>THEFT DETERRENT>SECURITY HORN ASSEMBLY>INSPECTION)
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT