2011-2016 FJ Cruiser · Service Manual BRAKE

INSPECTION

Inspection · Vehicles built from Jul 2007


INSPECT BRAKE CYLINDER AND PISTON
  1. Check the cylinder bore and piston for rust and scoring.
    If necessary, replace the disc brake cylinder and piston.


INSPECT PAD LINING THICKNESS

F043130E01
  1. Using a ruler, measure the pad lining thickness.

    Standard thickness:
    10.0 mm (0.394 in.)

    Minimum thickness:
    1.0 mm (0.039 in.)

    If the pad lining thickness is equal to or less than the minimum thickness, replace the disc brake pad kit.


INSPECT REAR DISC BRAKE PAD SUPPORT PLATE
  1. Make sure that the support plates have sufficient rebound, that there is no deformation, cracks or wear, and that all rust and dirt are removed.
    If necessary, replace the disc brake pad support plate.


INSPECT DISC THICKNESS

F043131E01
  1. Using a micrometer, measure the disc thickness.

    Standard thickness:
    18.0 mm (0.709 in.)

    Minimum thickness:
    16.0 mm (0.630 in.)

    If the disc thickness is less than the minimum, replace the rear disc.


INSPECT DISC RUNOUT
  1. Check the bearing play in the axial direction and check for the axle hub runout (Click here).

  1. F043187E01
    Provisionally fasten the rear disc together with the hub nuts.

    Torque:
    112 N*m{ 1,137 kgf*cm , 82 ft.*lbf }

  1. Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the rear disc.

    Maximum disc runout:
    0.20 mm (0.0079 in.)

    If the runout exceeds the maximum value, change the installation positions of the disc and axle to make the minimum runout. If the runout exceeds the maximum even when the installation positions are changed, grind the disc. If the disc thickness is less than the minimum, replace the rear disc.

← DISASSEMBLY (from Jul 2007)REASSEMBLY (from Jul 2007) →