HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Aug 2009 – Oct 2010
Versions by build date: Jul 2007 – Nov 2007 Dec 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012
- HINT:
- Use the following procedures to troubleshoot the cruise control system.
- *: Use a intelligent tester.
- Use the following procedures to troubleshoot the cruise control system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.PROBLEM SYMPTOM CONFIRMATION |
| |||||
| 3.CHECK CAN COMMUNICATION SYSTEM* |
-
Refer to the PRECAUTION (Click here).
Check for output DTCs.
- Result:
Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
B
- HINT:
- The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, be sure to check that there is no trouble in the CAN communication system.
|
|||||
| |||||
| 4.DTC CHECK AND CLEAR* |
- Refer to the DTC CHECK / CLEAR (Click here).
| |||||
| 5.DTC CHECK (OTHER THAN CAN SYSTEM DTC)* |
- Result:
Result
Proceed to
DTC is not output
A
DTC is output
B
|
|||||
| |||||
| 6.DTC CHART |
- Refer to the DIAGNOSTIC TROUBLE CODE CHART (Click here).
| |||||
| 7.PROBLEM SYMPTOM CONFIRMATION |
- Result:
Result
Proceed to
Symptom occurs
A
Symptom does not occur
B
|
|||||
| |||||
| 8.SYMPTOM SIMULATION |
- Refer to the ELECTRONIC CIRCUIT INSPECTION PROCEDURE (Click here).
| |||||
| 9.PROBLEM SYMPTOMS TABLE |
- Refer to the PROBLEM SYMPTOMS TABLE (Click here).
| |||||
| 10.CIRCUIT INSPECTION |
| |||||
| 11.TERMINALS OF ECM |
- Refer to TERMINALS OF ECM (Click here).
| |||||
| 12.IDENTIFICATION OF PROBLEM |
| |||||
| 13.REPAIR OR REPLACE |
| |||||
| 14.CONFIRMATION TEST |
| |||||