Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM
HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Aug 2012
Versions by build date: Jul 2007 – Nov 2007 Dec 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012
HINT:
Use the following procedures to troubleshoot the cruise control system.
*: Use the intelligent tester.
1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.INSPECT BATTERY VOLTAGE
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
NEXT
3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
Use the intelligent tester to check if the CAN communication system is functioning normally.
Result
Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
B
B.
A
Check for DTCs (Click here ).
Clear the DTCs (Click here ).
Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the cruise control system DTCs by simulating the conditions indicated by the DTCs.
Result
Result
Proceed to
DTC is not output
A
DTC is output
B
B.
A
Refer to Problem Symptoms Table (Click here ).
Result
Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
B.
A
6.OVERALL ANALYSIS AND TROUBLESHOOTING*
Road Test (Click here )
Terminals of ECM (Click here )
Data List / Active Test (Click here )
NEXT
7.ADJUST, REPAIR OR REPLACE
NEXT
NEXT