2011-2016 FJ Cruiser · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2012 Nov 2012 – Jul 2014 from Aug 2014


INSPECT FUEL INJECTOR ASSEMBLY

A095332E03
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 -2
      11.6 to 12.4 Ωat 20°C (68°F)

      If the result is not as specified, replace the fuel injector.

  1. A075912E01
    Check the injection volume.

    NOTICE:
    1. Perform the test in a well-ventilated area away from naked for flames.
    2. Handle the fuel tube connector carefully.


    1. B012947E08
      Install the fuel tube connector into SST (hose), then connect the tube connector to the fuel pipe.
      SST
      09268-31011   (95336-08070, 09268-41500)

      CAUTION:
      Connect the fuel tube connector (quick type) after observing the precautions.

    2. Remove the fuel pressure regulator (Click here).

    3. Install the O-ring onto the fuel inlet of the pressure regulator.

    4. A076630E01
      Connect SST (hose) to the fuel inlet of the pressure regulator with another SST (union) and the 2 bolts.
      SST
      09268-31011   (09268-41091, 95336-08070)

      Torque:
      9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    5. Connect the fuel return hose to the fuel outlet of the pressure regulator.

    6. A075914E03
      Install a new O-ring onto the injector.

    7. Connect SST (adaptor and hose) to the injector and hold the injector and union with SST (clamp).

      SST
      09268-31011   (95336-08070, 09268-41100)
      09268-41140  

    8. Set the injector in a graduated cylinder.

      CAUTION:
      Install a suitable vinyl tube onto the injector to prevent gasoline splashes.

    9. Connect the intelligent tester to the DLC3.

    10. Turn the ignition switch ON.

    11. Turn the intelligent tester ON.

    12. Select the following menu items: Powertrain / Engine and ECT / Active Test / Activate the Fuel Pump Speed Control / ON.

    13. Install SST onto the fuel injector.

    14. A075915E06
      Connect SST to the battery, then measure the injection volume for 15 seconds. Perform the inspection 2 or 3 times, then calculate the average.

      Standard::
      Injection Volume
      Difference Between Each Fuel Injector
      76 to 91 cm3 (4.6 to 5.5 cu in.) per 15 seconds
      15 cm3 (0.9 cu in.) or less

      NOTICE:
      Always do the switching at the battery side.

      If the result is not as specified, replace the fuel injector.

  1. Check for fuel leakage.

    1. When checking the injection volume, remove SST from the battery. Inspect the fuel leakage from the fuel injector.

      Standard:
      1 drop or less every 12 minutes.

      If the result is not as specified, replace the fuel injector.

← REMOVAL (from Aug 2014)INSPECTION (Aug 2009 – Oct 2012) →