2011-2016 FJ Cruiser · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2012 Nov 2012 – Jul 2014 from Aug 2014


1. DISCHARGE FUEL SYSTEM PRESSURE
  1. Discharge the fuel system pressure (Click here).


2. REMOVE INTAKE AIR SURGE TANK
  1. Remove the intake air surge tank (Click here).


3. REMOVE REAR CYLINDER HEAD COVER

  1. A224695
    Remove the 3 bolts and cover.


4. DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY

  1. A223035
    Disconnect the No. 1 fuel pipe sub-assembly (Click here).

    NOTICE:
    1. Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.
    2. The fuel tube connector seals with an O-ring. Ensure that there is no damage or foreign matter on the contact surface.
    3. If the connector and the pipe are stuck, push and pull on the connector to release them while pinching the retainer. Pull the connector out of the pipe carefully.
    4. Do not use any tools.
    5. Do not bend or twist the tubes.
    6. Protect the contact surface by covering it with a plastic bag.
    7. Do not damage any of the clips. If a clip is damaged, replace it.


5. DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY

  1. A223036
    Disconnect the No. 2 fuel pipe sub-assembly (Click here).

    NOTICE:
    1. Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.
    2. The fuel tube connector seals with an O-ring. Ensure that there is no damage or foreign matter on the contact surface.
    3. If the connector and the pipe are stuck, push and pull on the connector to release them while pinching the retainer. Pull the connector out of the pipe carefully.
    4. Do not use any tools.
    5. Do not bend or twist the tubes.
    6. Protect the contact surface by covering it with a plastic bag.
    7. Do not damage any of the clips. If a clip is damaged, replace it.


6. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

  1. A223037
    Disconnect the 6 fuel injector connectors.

  1. Remove the 4 bolts and fuel delivery pipe together with the 6 fuel injectors.

    NOTICE:
    Be careful not to drop the injectors when removing the fuel delivery pipe.


7. REMOVE FUEL INJECTOR ASSEMBLY

  1. A223038E02
    Pull the 6 fuel injectors from the fuel delivery pipe.
    Text in Illustration 
    *1
    Fuel Delivery Pipe
    *2
    Fuel Injector

  1. Remove the O-ring and injector vibration insulator from each fuel injector.

← REMOVAL (Nov 2012 – Jul 2014)INSPECTION (Jul 2007 – Jul 2009) →