PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Aug 2009 – Oct 2010
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Jul 2014 from Aug 2014
Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected Area |
See page |
| Noise |
1. Oil (level low) |
Click here
|
| 2. Oil (wrong) |
Click here
|
|
| 3. Transfer (faulty) |
Click here
|
|
| Oil leakage |
1. Oil (level too high) |
Click here
|
| 2. Gasket (damaged) |
Click here
|
|
| 3. Oil seal (worn or damaged) |
Click here
|
|
| 4. O-ring (worn or damaged) |
Click here
|
|
| Hard to shift or will not shift |
1. Shifting key spring (damaged) |
Click here
|
| 2. Synchronizer spring (worn or damaged) |
Click here
|
|
| Shift from 2WD (H2) to 4WD (H4) impossible |
1. Indicator switch (for 4WD position) |
Click here
|
| 2. Automatic disconnecting differential actuator |
Click here
|
|
| 3. Wire harness |
Click here
|
|
| 4. Skid control ECU with actuator |
Click here
|
|
| 5. ECM |
Click here
|
|
| 6. 4WD control ECU |
Click here
|
|
| Shift from 4WD (H4) to 2WD (H2) impossible |
1. Indicator switch (for 4WD position) |
Click here
|
| 2. Automatic disconnecting differential actuator |
Click here
|
|
| 3. Wire harness |
Click here
|
|
| 4. Skid control ECU with actuator |
Click here
|
|
| 5. ECM |
Click here
|
|
| 6. 4WD control ECU |
Click here
|
|
| Shift from 4WD (H4) to 4WD (L4) impossible |
1. Indicator switch (for 4WD position) |
Click here
|
| 2. Indicator switch (for L4 position) |
Click here
|
|
| 3. Indicator switch (for neutral position) |
Click here
|
|
| 4. Wire harness |
Click here
|
|
| 5. Skid control ECU with actuator |
Click here
|
|
| 6. ECM |
Click here
|
|
| Shift from 4WD (L4) to 4WD (H4) impossible |
1. Indicator switch (for 4WD position) |
Click here
|
| 2. Indicator switch (for L4 position) |
Click here
|
|
| 3. Indicator switch (for neutral position) |
Click here
|
|
| 4. Wire harness |
Click here
|
|
| 5. Skid control ECU with actuator |
Click here
|
|
| 6. ECM |
Click here
|