2011-2016 FJ Cruiser · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Aug 2009 – Oct 2012

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2012 Nov 2012 – Jul 2014 from Aug 2014


1. DISCHARGE FUEL SYSTEM PRESSURE
  1. Discharge the fuel system pressure (Click here).


2. REMOVE INTAKE AIR SURGE TANK
  1. Remove the intake air surge tank (Click here).


3. DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY

  1. A223036
    Disconnect the No. 2 fuel pipe sub-assembly (Click here).

    NOTICE:
    1. Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.
    2. The fuel tube connector seals with an O-ring. Ensure that there is no damage or foreign matter on the contact surface.
    3. If the connector and the pipe are stuck, push and pull on the connector to release them while pinching the retainer. Pull the connector out of the pipe carefully.
    4. Do not use any tools.
    5. Do not bend or twist the tubes.
    6. Protect the contact surface by covering it with a plastic bag.
    7. Do not damage any of the clips. If a clip is damaged, replace it.


4. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

  1. A223049
    Disconnect the vacuum hose.

  1. Remove the 2 bolts and fuel pressure regulator.

  1. Remove the O-ring from the fuel pressure regulator.

← REMOVAL (Jul 2007 – Jul 2009)REMOVAL (Nov 2012 – Jul 2014) →