REMOVAL
Removal / installation · Vehicles built Nov 2012 – Jul 2014
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2012 Nov 2012 – Jul 2014 from Aug 2014
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
Discharge the fuel system pressure (Click here).
| 2. REMOVE INTAKE AIR SURGE TANK |
Remove the intake air surge tank (Click here).
| 3. DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY |
Disconnect the No. 2 fuel pipe sub-assembly (Click here).

- NOTICE:
- Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.
- The fuel tube connector seals with an O-ring. Ensure that there is no damage or foreign matter on the contact surface.
- If the connector and the pipe are stuck, push and pull on the connector to release them while pinching the retainer. Pull the connector out of the pipe carefully.
- Do not use any tools.
- Do not bend or twist the tubes.
- Protect the contact surface by covering it with a plastic bag.
- Do not damage any of the clips. If a clip is damaged, replace it.
- Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.
| 4. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY |
Disconnect the vacuum hose.

Remove the 2 bolts and fuel pressure regulator.
Remove the O-ring from the fuel pressure regulator.
