2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Tachometer Malfunction

Circuit diagnosis · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 from Aug 2011

DESCRIPTION

The combination meter assembly controls the tachometer in accordance with engine speed signals from the ECM.

WIRING DIAGRAM

E148126E01

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (ENGINE SPEED)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List.

  1. According to the display on the tester, read the Data List.

    Engine and ECT 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Speed
    Engine speed:
    Min.: 0 rpm
    Max.: 16383.75 rpm
    650 to 750 rpm: Idling
    -

    OK:
    Engine speed displayed on the tester is approximately the same as the actual engine speed.



NG
GO TO SFI SYSTEM (Click here)
OK


2. CHECK WIRE HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)

  1. E126864E01
    Disconnect the E13 combination meter connector.

  1. Disconnect the E46 ECM connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    E13-12 (S) - E46-1 (TACH)
    Below 1 Ω
    E13-12 (S) or E46-1 (TACH) - Body ground
    10 kΩ or higher

  1. Reconnect the ECM connector.

  1. Reconnect the combination meter connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Speedometer Malfunction (from Aug 2012)Tachometer Malfunction (Aug 2009 – Oct 2010) →