2011-2016 FJ Cruiser · Service Manual BRAKE

DIAGNOSIS SYSTEM

Troubleshooting · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Jul 2008 Aug 2008 – Oct 2010 from Nov 2010


DIAGNOSIS
  1. If the skid control ECU detects a malfunction, the ABS and/or BRAKE warning lights and the slip indicator lights come on in accordance with the trouble area to warn the driver.

    HINT:
    1. The DTCs are simultaneously stored in the memory. The DTCs can be read by connecting SST between terminals 13 (TC) and 4 (CG) of the DLC3 and observing the blinking pattern of the ABS warning light and slip indicator light, or by connecting the intelligent tester.
    2. This system has a Test Mode sensor signal check function. Test mode DTCs can be read by connecting the intelligent tester and observing the blinking pattern of ABS warning light and slip indicator light.

    NOTICE:
    If parts connected to the IG terminal circuit are damaged due to high voltage, DTCs may not be able to be output from the ABS warning light and slip indicator light by connecting SST to the DLC3. In this case, inspect the IG power source circuit.


WARNING LIGHT AND INDICATOR LIGHT CHECK
  1. Release the parking brake.

    CAUTION:
    When releasing the parking brake, set chocks to hold the vehicle for safety.

    HINT:
    When the parking brake is applied or the level of the brake fluid is low, the BRAKE warning light comes on.

  2. Check that the ABS warning light, BRAKE warning light and slip indicator light come on when the ignition switch is turned to ON, and go off in approximately 3 seconds.

    HINT:
    If the indicator remains on or does not come on, proceed to troubleshooting for the light circuit below.
    Trouble Area
    See page
    ABS warning light circuit (Remains on)
    Click here
    ABS warning light circuit (Does not come on)
    Click here
    BRAKE warning light circuit (Remains on)
    Click here
    BRAKE warning light circuit (Does not come on)
    Click here
    Slip indicator light circuit (Remains on)
    Click here
    Slip indicator light circuit (Does not come on)
    Click here

← DIAGNOSIS SYSTEM (Aug 2008 – Oct 2010)DTC CHECK / CLEAR (Jul 2007 – Jul 2008) →