2011-2016 FJ Cruiser · Service Manual BRAKE

C1337/37 Diameter of the Tire is not Uniform

Diagnostic trouble codes · Vehicles built Jul 2007 – Oct 2010

DESCRIPTION

The skid control ECU measures the speed of each wheel by receiving signals from the speed sensors. These signals are used for recognizing whether all 4 wheels are operating properly. Therefore, all wheel signals must be equal.
DTC No.
DTC Detecting Condition
Trouble Areas
C1337/37
When either of following conditions detected:
  1. Diameters different of 2 front wheels and 2 rear wheels.
  2. Wheel speed sensor fault
  1. Speed sensor circuit
  2. Tire sizes
  3. Master cylinder solenoid (skid control ECU)

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. CHECK DTC
  1. Check if the DTC(s) relating to the speed sensor circuit is output (Click here).

    Result:
    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR SPEED SENSOR CIRCUIT
A


2. CHECK TIRE SIZE
  1. Check tire size and condition of all 4 wheels.

    OK:
    All 4 wheels are the same size and in the same condition.



NG
REPLACE TIRES SO THAT ALL 4 TIRES ARE SAME IN SIZE
OK


3. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Drive the vehicle at more than 20 km/h (13 mph) for more than 60 seconds.

  1. Check if the same DTC is detected (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID (Click here)


← C1337 Diameter of the Tire is not Uniform (from Aug 2012)C1380 Stop Light Control Relay Malfunction (Nov 2010 – Jul 2012) →