2011-2016 FJ Cruiser · Service Manual BRAKE

C1254/54 Pressure Switch Circuit

Diagnostic trouble codes · Vehicles built Jul 2007 – Oct 2010

DESCRIPTION

The accumulator pressure sensor is connected to the skid control ECU in the master cylinder solenoid.
C168949E01
DTC No.
DTC Detecting Condition
Trouble Areas
C1254/54
Accumulator pressure sensor fault
(Fluid pressure does not change when it should e.g. pump operates, brake pedal depressed/released).
  1. Master cylinder solenoid (skid control ECU)
  2. Hydraulic brake booster (accumulator pressure sensor)
  3. Hydraulic brake booster (master cylinder pressure sensor)

INSPECTION PROCEDURE


1. READ VALUE USING DATA LIST (ACCUMULATOR PRESSURE SENSOR)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch off.

  1. Depress the brake pedal more than 20 times.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Select the following menu items: Chassis / ABS/VSC/TRC/ Data List

    DATA LIST: ABS/VSC/TRC 
    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    Accumulator Sensor
    Accumulator pressure sensor reading / min.: 0 V, max.: 5 V
    3.58 to 5 V
    If value constant regardless of pump operation, accumulator pressure sensor malfunction suspected.

  1. Confirm whether the accumulator output voltage is normal.

    Result:
    Result
    Proceed to
    Output value normal
    A
    Output value not normal
    B



B
REPLACE HYDRAULIC BRAKE BOOSTER (Click here)
A


2. READ VALUE USING DATA LIST (MASTER CYLINDER PRESSURE SENSOR)
  1. Turn the ignition switch off.

  1. Depress the brake pedal more than 20 times.

  1. Install a brake pedal effort gauge (SST), and bleed air.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Select the following menu items: Chassis / ABS/VSC/TRC/ Data List

    DATA LIST: ABS/VSC/TRC 
    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    Master Cylinder Sensor1
    Master cylinder pressure sensor 1 reading / min.: 0 V, max.: 5 V
    0.3 to 1.9 V
    With pedal pressure of 49 N (5 kgf, 11 lbf)
    Front brake pressure: 770 to 1280 kpa (7.9 to 13.1 kgf/cm2, 112 to 186 psi)

  1. Check that the master cylinder output value is in the Normal Condition range.

    OK:
    Master cylinder pressure sensor value is in the Normal Condition.



NG
REPLACE HYDRAULIC BRAKE BOOSTER (Click here)
OK


3. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.

  1. Depress the brake pedal more than 20 times.

  1. Turn the ignition switch to ON.

  1. Wait until the pump motor stops.

  1. Depress the brake pedal and release it.

  1. Wait for 25 minutes.

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID (Click here)


← C1254 Pressure Sensor or Switch (from Aug 2012)C1256 Accumulator Low Pressure (Nov 2010 – Jul 2012) →