2011-2016 FJ Cruiser · Service Manual BRAKE

C1254 Pressure Sensor or Switch

Diagnostic trouble codes · Vehicles built from Aug 2012

Versions by build date: Nov 2010 – Jul 2012 from Aug 2012

DESCRIPTION

The accumulator pressure sensor is connected to the skid control ECU in the master cylinder solenoid.
C228612E01
DTC Code
DTC Detection Condition
Trouble Area
C1254
Accumulator pressure sensor fault
(Fluid pressure does not change when it should e.g. pump operates, brake pedal depressed/released).
Master cylinder solenoid (Accumulator pressure sensor)

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).


1. READ VALUE USING INTELLIGENT TESTER (ACCUMULATOR SENSOR)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Depress the brake pedal more than 40 times.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

    ABS/VSC/TRC 
    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    Accumulator Sensor
    Accumulator pressure sensor reading/ Min.:0.00 V, Max.:5.00 V
    3.85 to 5 V
    If the value is constant regardless of the pump operation, an accumulator pressure sensor malfunction is suspected.

  1. Check the accumulator output value.

    Result 
    Result
    Proceed to
    Output value is within "Normal Condition" range (after pump motor stops)
    A
    Output value is out of "Normal Condition" range (after pump motor stops)
    B
    Output value is constant regardless of pump operation



B
REPLACE MASTER CYLINDER SOLENOID (Click here)
A


2. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Depress the brake pedal more than 40 times.

  1. Turn the ignition switch to ON.

  1. Wait until the pump motor stops.

  1. Wait for 15 minutes.

  1. Depress the brake pedal and release it.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)


← C1254 Pressure Sensor or Switch (Nov 2010 – Jul 2012)C1254/54 Pressure Switch Circuit (Jul 2007 – Oct 2010) →