C1254 Pressure Sensor or Switch
Diagnostic trouble codes · Vehicles built Nov 2010 – Jul 2012
Versions by build date: Nov 2010 – Jul 2012 from Aug 2012
DESCRIPTION
The accumulator pressure sensor is connected to the skid control ECU in the master cylinder solenoid.

| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1254 |
Accumulator pressure sensor fault (Fluid pressure does not change when it should e.g. pump operates, brake pedal depressed/released). |
Master cylinder solenoid (Accumulator pressure sensor) |
INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform calibration (Click here).
| 1. READ VALUE USING INTELLIGENT TESTER (ACCUMULATOR SENSOR) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Depress the brake pedal more than 40 times.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
ABS/VSC/TRC Tester Display
Measurement Item / Range
Normal Condition
Diagnostic Note
Accumulator Sensor
Accumulator pressure sensor reading/ Min.:0.00 V, Max.:5.00 V
3.85 to 5 V
If the value is constant regardless of the pump operation, an accumulator pressure sensor malfunction is suspected.
Check the accumulator output value.
Result Result
Proceed to
Output value is within "Normal Condition" range (after pump motor stops)
A
Output value is out of "Normal Condition" range (after pump motor stops)
B
Output value is constant regardless of pump operation
|
|
||||
| A | |
| 2. RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Depress the brake pedal more than 40 times.
Turn the ignition switch to ON.
Wait until the pump motor stops.
Wait for 15 minutes.
Depress the brake pedal and release it.
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
