2011-2016 FJ Cruiser · Service Manual BRAKE

C1257/57 Power Supply Drive Circuit

Diagnostic trouble codes · Vehicles built Jul 2007 – Oct 2010

DESCRIPTION

The motor relay (semiconductor relay) is built into the hydraulic brake booster and drives the pump motor based on a signal from the skid control ECU.
DTC No.
DTC Detecting Condition
Trouble Areas
C1257/57
Open in pump motor input circuit
  1. Brake booster pump assembly
  2. Master cylinder solenoid (skid control ECU)

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. CHECK HYDRAULIC BRAKE BOOSTER PUMP MOTOR OPERATION
  1. Turn the ignition switch off.

  1. Disconnect the skid control ECU connector (A4).

  1. Depress the brake pedal more than 20 times.

  1. Turn the ignition switch to ON.

  1. Check the hydraulic brake booster pump motor operation.

    OK:
    Hydraulic brake booster pump operates.



NG
REPLACE BRAKE BOOSTER PUMP ASSEMBLY (Click here)
OK


2. RECONFIRM DTC
  1. Turn the ignition switch off.

  1. Reconnect the skid control ECU connector (A4).

  1. Turn the ignition switch to ON.

  1. Clear the DTC (Click here).

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID (Click here)


← C1257 Power Supply Drive Circuit (from Aug 2012)C1258/58 Transfer 4WD Position Switch Circuit (+ C1282/82) (Jul 2007 – Jul 2008) →