Engine Coolant Temperature Receiver Gauge Malfunction
Circuit diagnosis · Vehicles built Aug 2011 – Jul 2012
Versions by build date: Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Oct 2012 Nov 2012 – Jul 2014 from Aug 2014
DESCRIPTION
In this circuit, the meter CPU receives engine coolant temperature signals from the ECM using the CAN communication system (CAN V1 Bus). The meter CPU displays engine coolant temperature that is calculated based on the data received from the ECM.WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- If there is an open or short in the engine coolant temperature sensor circuit, the ECM stores the DTCs. Troubleshoot the SFI System (Click here).
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication DTC is output (Click here).
Result Result
Proceed to
CAN communication DTC is not output
A
CAN communication DTC is output
B
|
|
||||
| A | |
| 2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (WATER TEMPERATURE METER OPERATION) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
According to the display on the intelligent tester, perform the Active Test.
Combination Meter Tester Display
Test Part
Control Range
Diagnostic Note
Water Temperature Meter Operation
Engine coolant temperature receiver gauge
LOW, NORMAL or HIGH
Perform the test with the vehicle stopped and the engine idling.
- OK:
- Engine coolant temperature receiver gauge indication is normal.
|
|
||||
| OK | |
| 3. READ VALUE USING INTELLIGENT TESTER (COOLANT TEMPERATURE) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Data List.
According to the display on the intelligent tester, read the Data List.
Combination Meter Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Coolant Temperature
Engine coolant temperature/
Min.: 0 (32), Max.: 127.5 (261.5)
After warming up:
75 to 105 (167 to 221)
Unit: °C (°F)
- OK:
- Engine coolant temperature value displayed on the intelligent tester is almost the same as the engine coolant temperature receiver gauge indication.
|
|
||||
| OK | |
| 4. CHECK ENGINE CONTROL SYSTEM |
Check if a engine control DTC is output (Click here).
Result Result
Proceed to
Engine control DTC is not output
A
Engine control DTC is output
B
|
|
||||
| A | ||
| ||
